bw-mapped-interface
Use this command to configure modem interface where the shapers has to be applied. When Eth-BNM and Eth-CSF PDUs are received on Out-Of-Band interface, shapper will be updated on corresponding modem interface if this CLI is configured. Use <no> version of CLI to unconfigure modem interface mapping.
Command Syntax
bw-mapped-interface IFNAME
no bw-mapped-interface
Parameters
IFNAME
Specify the interface name where bandwidth shapers can be applied
Command Mode
Ethernet CFM MEP mode
Applicability
This command was introduced in OcNOS version 5.2
Examples
OcNOS(config)#ethernet cfm domain-type character-string domain-name abcde level 5
OcNOS(config-ether-cfm)#service ma-type string ma-name 7
OcNOS(config-ether-cfm-ma)#vlan 10 bridge 1
OcNOS(config-ether-cfm-ma)#ethernet cfm mep down mpid 100 active true xe9
OcNOS(config-ether-cfm-ma-mep)# bw-mapped-interface modem1
OcNOS(config-ether-cfm-ma-mep)#commit
Last modified date: 10/20/2023