ethernet cfm delay-measurement reply
Use this command to enable transmission of DMR (Delay Measurement Reply) PDUs for received DMMs (Delay Measurement Messages).
After this command is given, a delay measurement session cannot be configured to send DMMs. In that case, the device can only generate DMRs for received DMM PDUs.
Use the no form of this command to disable sending DMR PDUs. After no command is given we can thereby configure a delay measurement session to send DMMs if we need.
Command Syntax
ethernet cfm delay-measurement reply dmm
no ethernet cfm delay-measurement reply dmm
Parameters
None
Command Mode
Ethernet CFM MA MEP mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
OcNOS#configure terminal
OcNOS(config)# ethernet cfm domain-type no-name domain-name no_name level 4
OcNOS(config-ether-cfm)#service ma-type string ma-name 7
OcNOS(config-ether-cfm-ma)#vlan 10 bridge 10
OcNOS(config-ether-cfm-ma)#ethernet cfm mep down mpid 100 active true xe9
OcNOS(config-ether-cfm-ma-mep)#ethernet cfm delay-measurement reply dmm
Last modified date: 10/20/2023