ethernet cfm loss-measurement reply
Use this command to enable transmission of SLR (Synthetic Loss Reply) PDUs for received SLMs (Synthetic Loss Messages) and to enable transmission of LMR (Loss Measurement Reply) PDUs for received LMMs (Loss Measurement Messages).
After this command is given, a loss measurement session cannot be configured to send SLMs. In that case, the device can only generate SLRs for received SLM PDUs. The same is true for LMM/LMR also.
Use the no form of this command to disable sending SLR/LMR PDUs.
Command Syntax
ethernet cfm loss-measurement reply (slm | lmm)
no ethernet cfm loss-measurement reply (slm | lmm)
Parameters
slm
Synthetic Loss Messages
lmm
Loss Measurement Messages
Command Mode
Ethernet CFM MA MEP mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#configure terminal
(config)# ethernet cfm domain-type no-name domain-name no_name level 4 mip-creation none
OcNOS(config-ether-cfm)#service ma-type string ma-name 7
OcNOS(config-ether-cfm-ma)#vlan 10 bridge 1
OcNOS(config-ether-cfm-ma)#mip-creation none
OcNOS(config-ether-cfm-ma)#ethernet cfm mep down mpid 100 active true xe9
OcNOS(config-ether-cfm-ma-mep)#ethernet cfm loss-measurement reply slm
Last modified date: 10/20/2023