wait-to-restore-timer <0-86400>
Use this command to configure/unconfigure Wait-to-restore timer for Eth-BNM and Eth-CSF. For Eth-BNM, nominal bandwidth will be set after the wait-to-restore timer expiry. When this command is enabled for Eth-CSF 'DCI' state is restored after wait-to-restore timer expiry.
Command Syntax
wait-to-restore-timer <TIME>
no wait-to-restore-timer <TIME>
Parameters
TIME
Wait-to-restore-timer <0-86400>
Default
Default is 10 seconds.
Command Mode
Ethernet CFM MEP BN and CFM MEP CSF mode
Applicability
This command was introduced in OcNOS version 5.0
Examples
OcNOS(config)#ethernet cfm domain-type character-string domain-name abcde level 5
OcNOS(config-ether-cfm)#service ma-type string ma-name 7
OcNOS(config-ether-cfm-ma)#vlan 10 bridge 10
OcNOS(config-ether-cfm-ma)#ethernet cfm mep down mpid 100 active true xe9
OcNOS(config-ether-cfm-ma-mep)#bn receive
OcNOS(config-ether-cfm-ma-mep-bn)#wait-to-restore-timer 90
OcNOS(config-ether-cfm-ma-mep-bn)#
Last modified date: 10/20/2023