protection-port
Use this command to configure a protection-port for a g8031 protection group.
Use the no form of this command to delete protection-port for a g8031 protection group.
Note: When both working and protection ports are in Signal-Failure state, Working Port will be treated as Active port i.e Protection group will be in Signal-Failure-Protection State.
Note: Working and Protection Paths between two ELPS end nodes should not coincide i.e When having intermediate nodes it is required that the working path and protection path are configured via different intermediate nodes.
Note: Working port should be Layer-2 Physical or LAG interface. Command is not applicable for subinterface.
Note: Protection port should be Layer-2 Physical or LAG interface. Command is not applicable for subinterface.
Command Syntax
protection-port IFNAME
no protection-port
Parameters
IFNAME
Interface name.
Command Mode
G8031 Switching Mode.
Applicability
This command was introduced before OcNOS version 5.0.
Examples
#configure terminal
(config)#g8031 eps-id 10 bridge 1
(g8031-config-switching)#protection-port xe10
Last modified date: 10/20/2023