automatic-router-id-selection enable

OcNOS-SP : Layer 3 Guide : Fundamental Layer 3 Command Reference : Fundamental Layer 3 Commands : automatic-router-id-selection enable

Use this command to assure that OcNOS selects the loopback IP address as the router-id each time the device is rebooted.

Use the no form of this command to remove this constraint.

Command Syntax

automatic-router-id-selection enable

no automatic-router-id-selection enable

Parameters

None

Default

No default value is specified

Command Mode

Configure mode

Applicability

This command was introduced before OcNOS version 1.3.

Examples

#configure terminal

(config)#automatic-router-id-selection enable

(config)#

Last modified date: 10/16/2023