OcNOS-SP : Layer 3 Guide : Fundamental Layer 3 Command Reference : Fundamental Layer 3 Commands : ip urpf enable
ip urpf enable
Use this command to enable uRPF mode on the system.
Use the no form of the command to disable uRPF mode on this system.
Note: The configuration is applied only after a reboot.
Command Syntax
ip urpf enable
no ip urpf enable
Parameter
None
Default
By default, uRPF mode on the system is disabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#ip urpf enable
% System Reboot is required for new URPF configurations to take effect
 
(config)#no ip urpf enable
% System Reboot is required for new URPF configurations to take effect
Last modified date: 10/16/2023