OcNOS-SP : Layer 3 Guide : Fundamental Layer 3 Command Reference : Fundamental Layer 3 Commands : ip urpf allow-default
ip urpf allow-default
Use this command to enable default route check for uRPF mode.
Use no form of this command to disable default route check for uRPF mode.
Command Syntax
This command applies only to Qumran platforms.
ip urpf allow-default
no ip urpf allow-default
Parameter
None
Default
By default, uRPF mode on the system is disabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#ip urpf allow-default
 
(config)#no ip urpf allow-default
Last modified date: 10/16/2023