match vlan inner
Use this command to classify the traffic based on the inner VLAN.
Use the no command to remove the match configuration.
Note: The match commands which accept range has silent exit which makes removal of these match configuration easier. For example, classify the traffic based on the inner VLAN using the command match vlan inner 2,4,6 and remove the match configuration using the command no match vlan inner 2-6.
Command Syntax
match vlan inner WORD
Note: Below no command is applicable for class-map of type match-any.
no match vlan inner (WORD|all)
Note: Below no command is applicable for class-map of type match-all.
no match vlan inner
Parameters
WORD
Enter VLAN ID <1-4094> or list of VLAN ID's separated by commas. For example, 2,4 etc.
all
Delete all VLAN ID entries.
Default
No default value is specified
Command Mode
Class-map mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
(config)#class-map type qos C_QOS1
(config-cmap-qos)#match vlan inner 1
Last modified date: 10/20/2023