OcNOS-SP : Quality of Service Guide : Quality of Service Command Reference : Quality of Service Commands : set cos
set cos
Use this command for matching traffic classes set action as change CoS in the egress packet to the prescribed value.
Use the no command to remove the assigned value from the class.
Note: This command only applies to normal switch ports of type trunk/hybrid. This command does not apply to AC, CEP, or PNP ports. See the qos map-profile (Qumran) command for options for these types of ports.
Command Syntax
set cos <0-7>
no set cos
Parameters
<0-7>
Specify CoS value to assign for this class of traffic
Default
No default value is specified
Command Mode
Policy-map-class-qos mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
(config)#policy-map my_policy1
(config-pmap-qos)#class traffic_class2
(config-pmap-c-qos)#no set cos
(config-pmap-c-qos)#
Last modified date: 10/20/2023