trust dscp
Use this command to classify the traffic based on DSCP map on L2 port.
Use the no form of the command to remove the configuration.
Note: By default, the trust of L2 ports is CoS. If the user wants to map the traffic according to the DSCP value, trust dscp can be set on ports to achieve the requirement.
Tagged packet color is based on the DEI bit. Untagged packet color is based on DSCP value.
Out-DSCP option in dscp-to-queue profile is not applicable on L2 interfaces when trust DSCP is set
Only “default” dscp-to-queue profile is valid for trust DSCP. User-defined dscp-to-queue cannot be attached on L2 interfaces.
Command Syntax
trust dscp
no trust dscp
Parameters
trust
Configure port trust state
dscp
Classifies ingress packets with the packet DSCP values
Default
No default value is specified
Command Mode
Interface mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
(config)#interface xe1
(config-if)#trust dscp
Last modified date: 10/20/2023