loop-detection-path-vec-count
Use this command to set the loop detection vec (vector) count, which determines the maximum supported path vectors.
This command sets the maximum supported path vectors for loop detection, which specifies the permitted path vector length. An LSR that detects a path vector has reached the maximum length behaves as if the containing message has traversed a loop. This command ensures that a loop is detected while establishing a label switched path before any data is passed over that LSP.
Use the no parameter to revert to the default loop detection count
Command Syntax
loop-detection-path-vec-count <1-255>
Parameters
<1-255>
Indicates the loop detection hop count.
Default
By default, loop detection path vec count is disabled
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#router ldp
(config-router)#loop-detection-path-vec-count 123
Last modified date: 10/17/2023