router ldp
This command is used to enter the LDP specific command-line mode in which global attributes for the LDP process can be set. Without this command, the LSR does not perform any LDP operations, such as sending hello packets.
Use the no parameter with this command to disable this configuration.
Command Syntax
router ldp
no router ldp
Parameters
None
Default
By default, router ldp is disabled
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
The following example shows the change in the prompt after using this router ldp command to enter router mode.
#configure router
(config)#router ldp
(config-router)#
Last modified date: 10/17/2023