targeted-peer ipv4
Use this command to enter a targeted IPv4 LDP peer mode.
A targeted session is an LDP session between non-directly connected LSRs. Set this command to send a targeted hello messages to specific IP addresses. This command is specific to a targeted IPv4 LDP peer.
Command Syntax
targeted-peer ipv4 A.B.C.D
no targeted-peer ipv4 A.B.C.D
Parameter
A.B.C.D
Specify the IPv4 address of the targeted peer.
Default
By default, targeted peer IPv4 is disabled
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router ldp
(config-router)#targeted-peer ipv4 10.10.10.10
(config-router-targeted-peer)#
Last modified date: 10/17/2023