bridge cisco-interoperability
Use this command to enable/disable Cisco interoperability for MSTP (Multiple Spanning Tree Protocol).
If Cisco interoperability is required, all OcNOS devices in the switched LAN must be Cisco-interoperability enabled. When OcNOS inter operates with Cisco, the only criteria used to classify a region are the region name and revision level. VLAN-to-instance mapping is not used to classify regions when interoperating with Cisco.
Command Syntax
bridge <1-32> cisco-interoperability (enable | disable)
Parameters
<1-32>
Specify the bridge group ID
enable
Enable Cisco interoperability for MSTP bridge
disable
Disable Cisco interoperability for MSTP bridge
Default
By default, cisco interoperability is disabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
To enable Cisco interoperability on a switch for a bridge:
#configure terminal
(config)#bridge 2 cisco-interoperability enable
To disable Cisco interoperability on a switch for a particular bridge:
#configure terminal
(config)#bridge 2 cisco-interoperability disable
Last modified date: 10/12/2023