customer-spanning-tree customer-edge path-cost
Use this command to set the cost of a path associated with a customer edge port on a customer edge spanning tree.
Use the no form of this command to remove the cost of a path associated with a customer edge port on a customer edge spanning tree.
Command Syntax
customer-spanning-tree customer-edge path-cost <1-200000000>
no customer-spanning-tree customer-edge path-cost
Parameters
path-cost
Specify the path-cost of a port.
<1-200000000>
Specify the cost to be assigned to the group.
Default
Assuming a 10 Mb/s link speed, the default value is 200,000
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth1
(config-if)#customer-spanning-tree customer-edge path-cost 1000
Last modified date: 10/12/2023