customer-spanning-tree customer-edge priority
Use this command to set the port priority for a customer-edge port in the customer spanning tree.
Command Syntax
customer-spanning-tree customer-edge priority <0-240>
Parameters
priority
Specify the port priority.
<0-240>
Specify the port priority range (a lower priority indicates greater likelihood of the interface becoming a root). The priority values can only be set in increments of 16.
Default
By default, priority is 1
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth1
(config-if)#customer-spanning-tree customer-edge priority 100
Last modified date: 10/12/2023