customer-spanning-tree priority
Use this command to set the bridge priority for the spanning tree on a customer edge port. Using a lower priority indicates a greater likelihood of the bridge becoming root. This command must be used to set the priority of the customer spanning tree running on the customer edge port.
Use the no form of the command to reset it to the default value.
Command Syntax
customer-spanning-tree priority <0-61440>
no customer-spanning-tree priority
Parameters
<0-61440>
Specify the bridge priority in the range <0-61440>. Priority values can be set only in increments of 4096.
Default
By default, priority is 61440
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth1
(config-if)#customer-spanning-tree priority 4096
(config-if)#no customer-spanning-tree priority
Last modified date: 10/12/2023