spanning-tree edgeport
Use this command to set a port as an edge-port and to enable rapid transitions.
Use the no parameter with this command to set a port to its default state (not an edge-port) and to disable rapid transitions.
Note: This command is an alias to the spanning-tree portfast command. Both commands can be used interchangeably.
Command Syntax
spanning-tree edgeport
no spanning-tree edgeport
Default
By default, spanning-tree edgeport is disabled
Parameters
None
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth0
(config-if)#spanning-tree edgeport
Last modified date: 10/12/2023