vc-mode
Use this command to configure vc-mode as revertive for an mpls l2-circuit.
Use the no form of this command to remove the vc-mode.
Command Syntax
vc-mode revertive
no vc-mode revertive
Parameters
None
Command Mode
access-if-vpws mode
Applicability
This command was introduced in OcNOS version 5.0.
Examples
#configure terminal
(config)#interface xe1.1 switchport
(config-if)#access-if-vpws
(config-acc-if-vpws)#mpls-l2-circuit vc1 primary
(config-acc-if-vpws)#mpls-l2-circuit vc2 secondary
(config-acc-if-vpws)#vc-mode revertive
(config-acc-if-vpws)#end
Last modified date: 10/17/2023