split-horizon (subinterface)
Use this command to configure split-horizon group for L2 sub-interface.
Use the no form of this command to remove split-horizon group from L2 sub-interface.
Command Syntax
split-horizon group (network | access1 | access2)
no split-horizon group
Parameters
network
Split-horizon group name network
access1
Split-horizon group name access1
access2
Split-horizon group name access2
Default
By default, split horizon is disabled.
Command Mode
Interface mode
Applicability
This command was introduced in OcNOS version 6.3.0 and applicable only on Qumran1 devices..
Examples
#configure terminal
(config)#interface xe1.1 switchport
(config-if)#split-horizon group access1
(config-if)#no split-horizon group
Last modified date: 10/17/2023