group-id
Use this command to configure a specific group identifier to existing group with a group name in the MPLS layer-2 virtual circuit.
Use the no parameter with this command to remove group identifier from the MPLS layer-2 virtual circuit
Command Syntax
group-id <1-4294967295>
no group-id
Parameters
<1-4294967295>
Value for group identifier
Default
By default, group-id is disabled. If group-name is configured, default group-id is the first available identifier.
Command Mode
Configure Pseudowire mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
(config)#mpls l2-circuit mycircuit 45678 1.2.3.4
(config-pseudowire)#group-name group-1
(config-pseudowire)#group-id 11
Last modified date: 10/17/2023