manual-pseudowire
Use this command to configure the MPLS layer-2 virtual circuit as manual. This disables the default signalling mode of the MPLS layer-2 virtual circuit.
Use the no parameter with this command to disable manual mode of the MPLS layer-2 virtual circuit & enable signalling mode of the MPLS layer-2 virtual circuit.
Command Syntax
manual-pseudowire
no manual-pseudowire
Parameters
NA
Default
By default, manual-pseudowire is disabled
Command Mode
Configure Pseudowire mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#mpls l2-circuit mycircuit 45678 1.2.3.4
(config-pseudowire)#manual-pseudowire
Last modified date: 10/17/2023