mpls lsp-model uniform
Use this command to configure the MPLS LSP model as uniform.
Use the no parameter with this command to configure the MPLS LSP model as pipe or short-pipe.
Command Syntax
mpls lsp-model uniform
no mpls lsp-model uniform
Parameter
None
Default
By default, model configuration is pipe for XGS devices.
Qumran devices have the following default behavior:
• For L3VPN services, model is short-pipe by default and pipe model can be set by configuring policy-maps with match exp and set queue.
• For L2VPN services, short-pipe model is not supported and the default model is pipe.
• For L2VPN services with rewrite action pop, cos value will always be updated from qos profile irrespective of model.
• For L2VPN services without rewrite, uniform model command does not take effect until 'qos remark-cos' is configured on egress interface.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#mpls lsp-model uniform
(config)#exit
#configure terminal
(config)#no mpls lsp-model uniform
(config)#exit
Last modified date: 10/17/2023