signaling bgp
Use this command to establish a pseudowire connection between Provider Edge (PE) routers. Use this command to use the Border Gateway Protocol (BGP) for signaling and to support VPLS auto-discovery between VPLS instances.Using this command triggers BGP to auto-discover VPLS peers and signal pseudowire between the VPLS peers in the same VPLS instance.
Note: Issuing this command puts the router into VPLS signaling .
Use the no parameter with this command to remove (tear down) pseudowires with other PE routers.
Command Syntax
signaling bgp
no signaling bgp
Parameters
None
Default
By default, signaling bgp is disabled
Command Mode
VPLS mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)# mpls vpls test 100
(config-vpls)#signaling bgp
(config-vpls-sig)#exit
Last modified date: 10/17/2023