show ipv6 mroute
Use this command to display the IPv6 multicast routing (mroute) table. The routing table is based on the pairing of Source Addresses with their respective Destination Multicast Group Address (S, G).
Command Syntax
show ipv6 mroute (dense|sparse|) (count|summary|)
show ipv6 mroute X:X::X:X (dense|sparse|)(count|summary|)
show ipv6 mroute X:X::X:X X:X::X:X (dense|sparse|) (count|summary|)
show ipv6 mroute (vrf NAME|) (dense|sparse|) (count|summary|)
show ipv6 mroute (vrf NAME|) X:X::X:X (dense|sparse|) (count|summary|)
show ipv6 mroute (vrf NAME|) X:X::X:X X:X::X:X (dense|sparse|) (count|summary|)
Parameters
X:X::X:X
Source or Group IPv6 address.
count
Route and packet count data.
summary
Provide abbreviated display.
dense
Show dense multicast routes.
sparse
Show sparse multicast routes.
vrf
Specify the VRF name.
Command Mode
Exec and Privileged Exec mode
Applicability
This command was introduced in OcNOS version 6.2.0.
Example
The following is a sample output of this command displaying the IPv6 multicast routing table, with and without specifying the group and source IPv6 address:
rtr6#show ipv6 mroute
IPv6 Multicast Routing Table
Flags: I - Immediate Stat, T - Timed Stat, F - Forwarder installed
B - BIDIR
Timers: Uptime/Stat Expiry
Interface State: Interface
(5001::2, ff3e::1), uptime 00:00:16, stat expires 00:03:14
Owner PIM, Flags: TF
Incoming interface: xe17
Outgoing interface list:
xe18 (1)
Last modified date: 10/20/2023