ipv6 mld
Use this command to enable the MLD protocol operation on an interface. This command enables MLD protocol operation in stand-alone mode, and can be used to learn local-membership information prior to enabling a multicast routing protocol on the interface. This command will has no effect on interfaces configured for MLD Proxy.
Note: This command can only be issued on VLAN interfaces.
Use the no parameter with this command to return all MLD related configuration to the default or MLD Proxy service.
Command Syntax
ipv6 mld
no ipv6 mld
Parameters
None
Default
Disabled
Command Mode
Interface mode for VLAN interface
Applicability
This command was introduced in OcNOS version 6.2.0.
Example
#configure terminal
(config)#interface eth1
(config-if)#ipv6 mld
Last modified date: 10/20/2023