ipv6 mld limit
Use this command to set the limit on the maximum number of group membership states at either the router level, or for the specified interface. Once the specified number of group memberships is reached, all further local-memberships will be ignored. Optionally, an exception access-list can be configured to specify the group-address(es) to be excluded from being subject to the limit.
This command applies to interfaces configured for MLD Layer-3 multicast protocols, or MLD Proxy.
Use the no parameter with this command to unset the limit and any specified exception access-list.
Command Syntax
ipv6 mld limit <1-2097152> (except WORD |)
ipv6 mld (vrf NAME|) limit <1-2097152> (except WORD |)
no ipv6 mld limit
Parameters
vrf
Specify the VRF name.
<1-2097152>
Maximum number of group membership states.
except
Standard IPv6 access-list name that defines multicast groups which are exempted from being subject to the configured limit.
WORD
Specify the standard IPv6 access-list name.
Default
The default value is 0 (zero).
Command Mode
Configure mode and Interface mode
Applicability
This command was introduced in OcNOS version 6.2.0.
Examples
The following example configures an MLD limit of 100 group-membership states across all interfaces on which MLD is enabled, and excludes group 224.1.1.1 from this limitation:
#configure terminal
(config)#ipv6 mld limit 100 except v6grp
The following example configures an MLD limit of 100 group-membership states on eth0:
#configure terminal
(config)#interface eth0
(config-if)#ipv6 mld limit 100
Last modified date: 10/20/2023