ipv6 mld robustness-variable
Use this command to set the robustness variable value on an interface. This command applies to interfaces configured for MLD Layer-3 multicast protocols, or MLD Proxy.
Use the no parameter with this command to return to the default value on an interface.
Command Syntax
ipv6 mld robustness-variable <2-7>
no ipv6 mld robustness-variable
Parameter
<2-7>
Specify a robustness variable value in seconds.
Default
Default robustness value is 2 seconds.
Command Mode
Interface mode
Applicability
This command was introduced in OcNOS version 6.2.0.
Example
#configure terminal
(config)#interface 0
(config-if)#ipv6 mld robustness-variable 3
Last modified date: 10/20/2023