ipv6 mld ssm-map static
Use this command to specify the static mode of defining SSM mapping. SSM mapping statically assigns sources to MLDv1 groups to translate such (*,G) groups’ memberships to (S,G) memberships for use with PIM-SSM. This command applies to interfaces configured for MLD Layer-3 multicast protocols, or MLD Proxy.
Use the no parameter with this command to remove the SSM map association.
Command Syntax
ipv6 mld ssm-map static WORD X:X::X:X
ipv6 mld (vrf NAME|) ssm-map static WORD X:X::X:X
no ipv6 mld ssm-map static WORD X:X::X:X
no ipv6 mld (vrf NAME|) ssm-map static WORD X:X::X:X
Parameters
vrf
Specify the VRF name.
WORD
Specify IPv6 named standard access-list.
X:X::X:X
Specify IPv6 address.
Command Mode
Configure mode
Applicability
This command was introduced in OcNOS version 6.2.0.
Example
This example shows how to configure an SSM static mapping for group-address ff0e::1/128.
#configure terminal
(config)#ipv6 mld ssm-map static v6grp 2006::3
(config)#ipv6 access-list v6grp permit ff0e::1/128
Last modified date: 10/20/2023