mld snooping report-suppression
Use this command to enable report suppression for MLD version 1.
Use the no parameter to disable report suppression.
Note: MLD Snooping command can only be configured on VLAN interfaces. MLD snooping report suppression is supported on x86 and not supported on Qumran devices.
Command Syntax
mld snooping report-suppression
no mld snooping report-suppression
Parameters
None
Default
By default, MLD snooping report suppression is enabled on x86.
Command Mode
Interface mode for VLAN interface
Applicability
This command was introduced in OcNOS version 3.0.
Examples
#configure terminal
(config)#interface vlan1.100
(config-if)#mld snooping report-suppression
(config-if)#exit
Last modified date: 10/20/2023