ip igmp last-member-query-count
Use this command to set the last-member query-count value. This command applies to interfaces configured for IGMP Layer-3 multicast protocols and IGMP Proxy.
Use the no parameter with this command to return to the default value on an interface.
Command Syntax
ip igmp last-member-query-count <2-7>
no ip igmp last-member-query-count
Parameter
<2-7>
Specify the last member query count value.
Default
The default last member query count value is 2.
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth1
(config-if)#ip igmp last-member-query-count 3
Last modified date: 10/20/2023