OcNOS-SP : Multicast Guide : Multicast Configuration Guide : PIM Sparse Mode Configuration : PIM-SM Configuration
PIM-SM Configuration
PIM-SM is a soft-state protocol. The required steps to configure PIM-SM are the following:
• Enable IP multicast on each PIM router (see Enabling IP Multicast Routing)
• Enable PIM-SM on the desired interfaces (see Enable IPV6 Multicast Routing)
• Configure the RP statically (see Configuring Rendezvous Point Statically or dynamically (see Configure Rendezvous Point Dynamically Using Bootstrap Router Method) depending on which method you use)
Last modified date: 10/20/2023