ipv6 nd link-mtu
Use this command to set an advertised maximum transmission unit (MTU).
Use the no option with the command to reset the MTU to the default statute.
Command Syntax
ipv6 nd link-mtu (<1280-65535>)
no ipv6 nd link-mtu
Parameters
<1280-65535>
Link MTU value.
Default
By default, link MTU value is 1500
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth3
(config-if)#ipv6 nd link-mtu 1600
(config-if)#no ipv6 nd link-mtu
Last modified date: 10/16/2023