ipv6 router ospf
Use this command to enable OSPFv3 routing on an interface.
Specify the process ID to configure multiple instances of OSPFv3. When running a single instance of OSPFv3, you do not need to specify a instance ID.
When OSPFv3 receives a packet, it checks if the instance ID in the packet matches the instance ID of the receiving interface.
Use the no parameter with this command to disable OSPFv3 routing on an interface.
Command Syntax
ipv6 router ospf area (A.B.C.D|<0-4294967295>)
ipv6 router ospf area (A.B.C.D|<0-4294967295>) instance-id (<0-31>|<64-95>)
ipv6 router ospf area (A.B.C.D|<0-4294967295>) tag WORD
ipv6 router ospf area (A.B.C.D|<0-4294967295>) tag WORD instance-id (<0-31>|<64-95>)
ipv6 router ospf tag WORD area (A.B.C.D|<0-4294967295>)
ipv6 router ospf tag WORD area (A.B.C.D|<0-4294967295>) instance-id (<0-31>|<64-95>)
no ipv6 router ospf area (A.B.C.D|<0-4294967295>)
no ipv6 router ospf area (A.B.C.D|<0-4294967295>) instance-id (<0-31>|<64-95>)
no ipv6 router ospf area (A.B.C.D|<0-4294967295>) tag WORD
no ipv6 router ospf area (A.B.C.D|<0-4294967295>) tag WORD instance-id (<0-31>|<64-95>)
no ipv6 router ospf tag WORD area (A.B.C.D|<0-4294967295>)
no ipv6 router ospf tag WORD area (A.B.C.D|<0-4294967295>) instance-id (<0-31>|<64-95>)
Parameters
area
OSPF Area ID in IPv4 address format.
A.B.C.D
OSPF area ID in IP address format.
<0-4294967295>
OSPF area ID as a decimal value.
instance-id
Specify the instance.
<0-31>
Interface instance ID for IPv6 unicast
<64-95>
Interface instance ID for IPv4 unicast.
tag
Tag value to use as a “match” value for controlling redistribution via route maps.
WORD
Set the tag value.
Default
By default, ipv6 router ospf is disabled
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth0
(config-if)#ipv6 router ospf area 1 tag Tag1 instance-id 1
Last modified date: 10/16/2023