ipv6 te-metric
Use this command to set the traffic engineering metric for an interface.
The traffic engineering metric is used in OSPF-TE Link State Advertisements. If the traffic engineering metric is not set, the
ipv6 ospf cost value for an interface is used in OSPF-TE Link State Advertisements.
Use the no parameter with this command to unset the traffic engineering metric for this interface.
Command Syntax
ipv6 te-metric <1-65535>
ipv6 te-metric <1-65535> instance-id (<0-31>|<64-95>)
no ipv6 te-metric
no ipv6 te-metric instance-id (<0-31>|<64-95>)
Parameters
te-metric
Specify the TE metric.
<1-65535>
Specify the TE metric value.
instance-id
Specify the instance.
<0-31>
Interface instance ID for IPv6 unicast
<64-95>
Interface instance ID for IPv4 unicast.
Default
By default, traffic engineering metric value is 0
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth0
(config-if)#ipv6 te-metric 6
Last modified date: 10/16/2023