ipv6 pim register-source
Use this command to configure the source address of Register packets sent by this DR, overriding the default source address, which is the address of the RPF interface toward the source host.
Use the no option to remove the source address of register packets sent by this DR, and reset it to use the default source address, that is, the address of the RPF interface toward the source host.
The configured address must be a reachable address so the RP can send corresponding Register-Stop messages in response. This address is usually the loopback interface address, but can also be other physical addresses. The address must be advertised by unicast routing protocols on the DR.
Note: The interface configured does not require PIM to be enabled.
Command Syntax
ipv6 pim (vrf NAME|) register-source (X:X::X:X |IFNAME)
no ipv6 pim (vrf NAME|) register-source
Parameters
vrf
The VPN routing/forwarding instance
NAME
Specify the name of the VPN routing/forwarding instance
X:X::X:X
The IP address to be used as the source of the register packets
IFNAME
The name of the interface to be used as the source of the register packets
Command mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#ipv6 pim register-source 3ffe:406::1
#configure terminal
(config)#no ipv6 pim register-source
Last modified date: 10/20/2023