backup-bw-type
Use this command to select the bypass trunk bandwidth support type.
Bypass trunks of dedicated bandwidth type will serve only bandwidth protections requested LSPs. The total bandwidth requirement of served LSPs will be less than or equal to the bandwidth configured on the bypass trunk. If an LSP with bandwidth protection and higher setup priority requests protection and bypass doesn't have sufficient bandwidth available, then LSPs with lower hold priority will be preempted to serve the LSP with higher setup priority.
Use the no parameter to remove configured backup bandwidth type.
Command Syntax
backup-bw-type (dedicated | best-effort)
no backup-bw-type
Parameters
dedicated
Dedicated backup bandwidth support
best-effort
Best effort backup bandwidth support
Default
The default backup bandwidth type for bypass tunnel is best-effort.
Command Mode
Bypass mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
#configure terminal
(config)#rsvp-bypass bp1
(config-bypass)#backup-bw-type dedicated
Last modified date: 10/17/2023