bypass-lsp-addr-query-interval
Use this command to set the interval at which bypass trunk must query CSPF for LSP address. This mechanism ensures to update bypass trunk LSP addresses regularly so that, it can verify regularly if it can protect any LSP requesting protection.
Use the no parameter with this command to reset the interval to default value.
Note: Reducing interval to lower values may impact performance.
Command Syntax
bypass-lsp-addr-query-interval <10-60>
no bypass-lsp-addr-query-interval
Parameter
<10-60>
Set interval of bypass trunk querying LSP address
Default
By default, interval is set to 60 seconds.
Command Mode
Router mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
#configure terminal
(config)#router rsvp
(config-router)# bypass-lsp-addr-query-interval 50
Last modified date: 10/17/2023