rsvp-bypass
Use this command to create a new RSVP bypass trunk. When the bypass trunk is created, the attributes required to configure an explicitly-routed or traditionally-routed LSP are set. Once a trunk is configured with the required attributes, an RSVP bypass session (and PSB) is created for this trunk, which enables the exchange of messages and completes the LSP setup.
This command also modifies an existing RSVP path to configure an explicitly-routed or traditionally-routed LSP.
Use the no parameter with this command to remove an RSVP bypass trunk and all configured attributes.
Note: The RSVP bypass' name (BYPASSNAME) is limited to 32 characters.
Command Syntax
rsvp-bypass BYPASSNAME
no rsvp-bypass BYPASSNAME
Parameters
BYPASSNAME
Name to use for the bypass trunk
Default
By default, rsvp bypass trunk is disabled
Command Mode
Configure mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
The command prompt changes from config to config-bypass as illustrated below:
#configure terminal
(config)#rsvp-bypass bp1
(config-bypass)#
Last modified date: 10/17/2023