to A.B.C.D
Use this command to specify an IPv4 egress for a bypass LSP. When configuring an LSP, you must specify the address of the egress router by using this command in the bypass node. An egress definition is a mandatory attribute; no RSVP session is created when an egress is not defined.
Use the no parameter with this command to unset the configured egress address.
Command Syntax
to A.B.C.D
no to
Parameters
None
Default
The operator must specify an egress for LSP initialization to begin.
Command Mode
Bypass mode
Applicability
This command was introduced in OcNOS version 3.0.
Examples
#configure terminal
(config)#rsvp-bypass bp1
(config-bypass)#to 10.10.0.5
Last modified date: 10/17/2023