entropy-label-capability
Use this command to share the load across multiple members of a LAG port in the core of an MPLS network by using entropy labels.
Use the no form of the command to disable the use of entropy labels
Note: Load balancing is enabled by default for all the parameters. If you enable load balancing manually, then all the parameters enabled by default are reset and you need to enable the parameters based on which traffic should be load balanced.
Command Syntax
entropy-label-capability
no entropy-label-capability
Parameters
None
Default
By default, entropy labels are not used.
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 3.0.
Examples
#configure terminal
(config)router rsvp
(config-router)#entropy-label-capability
Last modified date: 10/17/2023