neighbor A.B.C.D
Use this command to designate a neighbor IPv4 address to use when exchanging hello messages. Any neighbor hello message that is not explicitly identified is rejected.
Use the no parameter with this command to remove an IP neighbor from the system.
Command Syntax
neighbor A.B.C.D
no neighbor A.B.C.D
Parameters
None
Default
By default, neighbor A.B.C.D is disabled
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router rsvp
(config-router)#neighbor 10.10.0.5
Last modified date: 10/17/2023