OcNOS-SP : Multi-Protocol Label Switching Guide : RSVP-TE Command Reference : RSVP-TE Commands : no loop-detection
no loop-detection
Use this command to turn off loop detection for Path and Reservation messages exchanged between LSRs. When a Path or Resv message is received, the primary IP address of the incoming interface is compared with the received route record list.
Use the loop-detection command to revert to default settings.
Command Syntax
no loop-detection
Parameters
None
Default
By default, no loop detection is disabled
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router rsvp
(config-router)#no loop-detection
 
Last modified date: 10/17/2023