primary reuse-route-record
Use this command to use the updated Route Record List as an Explicit Route (with all strict nodes) when a path message is sent out at the next refresh.
The ERO list contains the hops to be taken to reach the egress from the current LSR. If CSPF is not available, to place an ERO with all strict routes, use this command to modify the ERO after receiving the Resv message. The future Path messages have the ERO with all strict nodes, identifying each and every node to be traversed.
Use the no parameter with this command to disable the use of the Route Record List as the explicit route.
Command Syntax
primary reuse-route-record
no primary reuse-route-record
Parameters
None
Default
By default, primary reuse route record is disabled
Command Mode
Trunk mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#rsvp-trunk mytrunk
(config-trunk)#primary reuse-route-record
Last modified date: 10/17/2023