show rsvp trunk multi-sec-detail
Use this command to display secondary priority details specific to a trunk or for all trunks
Command Syntax
show rsvp trunk multi-sec-detail
show rsvp trunk NAME multi-sec-detail
Parameters
NAME
Enter the name of a trunk
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
# show rsvp trunk multi-sec-detail
Ingress (Secondary-Priority1)
5.5.5.5
From: 6.6.6.6, LSPstate: Dn, LSPname: t2-Secondary-Priority-1
Ingress FSM state: Idle
Setup priority: 7, Hold priority: 0
CSPF usage: Enabled, CSPF Retry Count: 0, CSPF Retry Interval: 30 seconds
LSP Re-Optimization: Disabled, Re-Optimization Timer: NA
IGP-Shortcut: Disabled, LSP metric: 65
LSP Protection: None
Label in: -, Label out: -,
Tspec rate: 0, Fspec rate: 0
Policer: Not Configured
Tunnel Id: 5001, LSP Id: 2206, Ext-Tunnel Id: 6.6.6.6
Last Recorded Error Code: Routing Problem (24)
Last Recorded Error Value: No route available toward destination (5)
Node where Last Recorded Error originated: None
Trunk Type: mpls
Ingress (Secondary-Priority3)
5.5.5.5
From: 6.6.6.6, LSPstate: Dn, LSPname: t2-Secondary-Priority-3
Ingress FSM state: Idle
Setup priority: 7, Hold priority: 0
CSPF usage: Enabled, CSPF Retry Count: 0, CSPF Retry Interval: 30 seconds
LSP Re-Optimization: Disabled, Re-Optimization Timer: NA
IGP-Shortcut: Disabled, LSP metric: 65
LSP Protection: None
Label in: -, Label out: -,
Tspec rate: 0, Fspec rate: 0
Policer: Not Configured
Tunnel Id: 5001, LSP Id: 2206, Ext-Tunnel Id: 6.6.6.6
Last Recorded Error Code: Routing Problem (24)
Last Recorded Error Value: No route available toward destination (5)
Node where Last Recorded Error originated: None
Trunk Type: mpls
Last modified date: 10/17/2023