preference
Use this command to set a preference value for a candidate path.
Use the no form of this command to remove a preference value from a candidate path.
Command Syntax
preference <1-65535>
no preference
Parameters
<1-65535>
Preference for candidate path
Default
By default, preference value is 100 for a candidate path.
Command Mode
Candidate path mode
Applicability
This command was introduced in OcNOS version 4.0.
Example
#configure terminal
(config)#segment-routing
(config-sr)#traffic-engineering
(config-sr-te)#policy SR_POLICY_1
(config-sr-pol)#candidate-path 1
(config-sr-pol-cp)#preference 200
(config-sr-pol-cp)#
Last modified date: 10/20/2023