OcNOS-SP : Command Line Interface : Command Line Errors
Command Line Errors
Any unknown spelling causes the CLI to display the error Unrecognized command in response to the ?. The CLI displays the command again as last entered.
> show dd?
% Unrecognized command
> show dd
When you press the Enter key after typing an invalid command, the CLI displays:
(config)#router ospf here
^
% Invalid input detected at '^' marker.
where the ^ points to the first character in error in the command.
If a command is incomplete, the CLI displays the following message:
> show
% Incomplete command.
Some commands are too long for the display line and can wrap mid-parameter or mid-keyword, as shown below. This does not cause an error and the command performs as expected:
area 10.10.0.18 virtual-link 10.10.0.19 authent
ication-key 57393
Command Negation
Many commands have a no form that resets a feature to its default value or disables the feature. For example:
The ip address command assigns an IPv4 address to an interface
The no ip address command removes an IPv4 address from an interface
Last modified date: 07/10/2023