mac access-list
Use this command to define a MAC access control list (ACL) that determines whether to accept or drop an incoming packet based on specifications configured under the ACL. An ACL is made up of one or more ACL specifications.
Each packet that arrives at the device is compared to each specification in each ACL in the order that they are defined. The device continues to look until it has a match. If no match is found and the device reaches the end of the list, the packet is denied by default. For this reason, place the most frequently occurring specifications at the top of the list.
The device stops checking the specifications after a match occurs.
There is an implied deny specification for traffic that is not permitted. Implied specification can be updated to permit if the use-case is to deny a certain set of traffic.
Use the no form of this command to remove an ACL.
Command Syntax
mac access-list NAME
no mac access-list NAME
Parameters
NAME
Access-list name.
Default
No default value is specified
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#mac access-list mac-acl-01
(config-mac-acl)#exit
Last modified date: 10/19/2023