exec-timeout
Use this command to set the interval the command interpreter waits for user input detected. That is, this sets the time a telnet session waits for an idle VTY session before it times out. A value of zero minutes and zero seconds (0 and 0) causes the session to wait indefinitely.
Use the no parameter to disable the wait interval.
Command Syntax
exec-timeout <0-35791> (<0-2147483>|)
no exec-timeout
Parameters
<0-35791>
Timeout value in minutes.
<0-2147483>
Timeout value in seconds.
Default
No default value is specified
Command Mode
Line mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
In the following example, the telnet session will timeout after 2 minutes, 30 seconds if there is no response from the user.
Router#configure terminal
Router(config)#line vty 23 66
Router(config-line)#exec-timeout 2 30
Last modified date: 10/19/2023